There are all router commands available.

Entering the enable command will take you to global configuration mode.

The “>” symbol appears at the end of the device prompt for this mode.

It is possible to configure interfaces and routing protocols.

Only a portion of the router setup is visible.

The correct answer is these two:

Only a portion of the router setup is visible.

The “>” symbol appears at the end of the device prompt for this mode.

Explanation: In User EXEC mode, some show and debug commands are disabled. When setting a router, the first level of user interface you’ll see is for studying the device’s functions. The user EXEC prompt is identified by the “>” mark.